Choose the suitable collet from BS5535, slide the bevel side of collet through the bearing. Ensure the collet is stuck in the bearing. Remove the spindle nut from the collet. Lock the screw threaded rod on the tap rod. Use the sliding hammer back and forth impacting the handle of tap rod to simply tap the bearing out. Select the fitting collet from the kit BS5535 and slide the bevel side of collet through the bearing. Make sure the collet is stuck with the bearing. Reverse the tire to the other side. Heighten the tire by adding some stuff. Take off the sliding hammer. Install the tap head on the tap rod. Put the locating bushing into the wheel center bore. Insert the hand grip protector to prevent the injuries during the operation. Apply the rubber hammer on the tap rod until the bearing is been removed.