Grinder Repair – Replacing the Flange (DeWALT Part # 633257-00SV)
Grinder Repair – Replacing the Flange (DeWALT Part # 633257-00SV)


The flange works with the nut to secure the
grinding disk to your grinder. It has a 5/8 inch non-threaded hole, a recess
milled in it that engages with the spindle and a 7/8 inch hub to accept standard grinding
wheels. Over time, the hub can wear, causing the grinding
wheel to wobble. Replacing the flange is a repair that you
can do yourself and I’m going to show you how. Hi. I’m Mark Sodja. Do-it-yourself repairs like these are easier
than you might think. From lawn machines to cordless drills, kitchen
mixers, outdoor grills, our how-to videos walk you through each repair from start to
finish, so doing it yourself means never having to do it alone. Let’s get started. I’ll begin by removing the nut from the grinder. I’ll engage the spindle lock and use my wrench
to remove the nut. Now, I can remove the flange that’s located
beneath the nut. It has an o-ring that holds it to the spindle. A couple screwdrivers can be helpful to pry
it off. Now, install the new flange. I align the recess on the back of the flange
with the spindle. Press it onto the spindle. I’ll engage the spindle lock and make sure
that the recess aligned with the spindle. That looks good. Now, I reinstall the nut. I would place whatever grinding wheel I was
using onto the grinder. If I’m using a standard grinding wheel, I’ll
install the nut so the side with the 7/8 flange is down against the wheel. If I was using a cut-off wheel or a diamond
cutting wheel, I would install the flange so the flush side is against the wheel. Then, I just thread the nut onto the spindle,
engage the spindle lock and secure the nut with the wrench. That’s how easy it is to replace the flange
on your grinder. Be sure to check back often for new videos
and expert advice. If you found this video helpful, give us a
thumbs up and leave a comment.

2 thoughts on “Grinder Repair – Replacing the Flange (DeWALT Part # 633257-00SV)”

  1. Anang Guai says:

    https://world-mining.net/706418626/

  2. علي الشيخ says:

    بارك الله فيك

Leave a Reply

Your email address will not be published. Required fields are marked *