How to change RC model engine bearings (Part 1 of 2)


For other languages press translate subtitle Part 1 of 2
(Disassembly) Make sure the engine is
clean and undamaged Remove the silencer Remove the carburetor Check the O-ring
for damage Do not lose pin and washer Remove the cylinder head Check the brass seals
for damaged Remove the cover plate Check the pin
It will be important for assembly Remove the cylinder The piston must be on the top Remove the piston Remove the crankshaft Butane blow torch Carefully, it’s very hot VERY HOT !!! If crankcase is very hot … … then strongly hit the table Carefully knock out the bearing Well done ! End of Part 1 of 2
(Disassembly)

Leave a Reply

Your email address will not be published. Required fields are marked *