How to replace rear shock absorbers DODGE CALIBER TUTORIAL | AUTODOC
How to replace rear shock absorbers DODGE CALIBER TUTORIAL | AUTODOC


Use an end bit №5 and a combination spanner
№15 Use a socket №18 and a combination spanner №18 Use a socket №13 Use a socket №18 and a combination spanner №18 Use a socket №10 Use a combination spanner №15 Using a special tool take out the spring Use an open-end wrench №15 and an ajustable spanner Before installing new shock absorbers it is strongly recommended to pump them over for 3-5 times manually

5 thoughts on “How to replace rear shock absorbers DODGE CALIBER TUTORIAL | AUTODOC”

  1. Mr. Nobody says:

    Thanks for the latest video very helpful and fun to watch content.

  2. drawing fun says:

    very helpful… engine rebuild video?

  3. Kefta 4ever says:

    Thanks for the informative video, but unless people have a shop, its not that helpful. If you have a shop with all these tools then you probably don't need to watch this video. It does show which bolts to take off though.

  4. cowboyk64 says:

    Arm in the way getting bolts started , Music dont help ………………..

  5. Jim_Mitchell aka/jmgargoyle says:

    A commentary instead of the horrendous music would do wonders for this video? That any he could state the sizes ok f wrenches or sockets used instead of making people continuously stopping the video to zoom in to see what hes doing /using….

Leave a Reply

Your email address will not be published. Required fields are marked *