How to replace rear wheel bearing / rear hub bearing on VW POLO 4 (9N)  [TUTORIAL AUTODOC]
How to replace rear wheel bearing / rear hub bearing on VW POLO 4 (9N) [TUTORIAL AUTODOC]


Required tools:
Wire brush
WD-40 spray
All-purpose cleaning spray Copper grease
12-point socket # 30
Wheel impact socket #17
Torque wrench Tap wrench
Hammer
Rubber mallet Phillips screwdriver
Crow bar
Wheel chock 1. Raise the rear of the car and secure on supports. 2. Unscrew the wheel bolts.
Use wheel impact socket #17. AUTODOC recommends:
To avoid injury, hold up the wheel when unscrewing the bolts. 3. Clean the brake drum.
Use a wire brush. Use WD-40 spray. 4. Unscrew the brake drum fastening
Use a Phillips screwdriver. 5. Remove the brake drum. AUTODOC recommends:
Examine the brake drum. Replace it if necessary. 6. Remove the hub bearing protection cap.
Use a hammer. Use a crowbar. AUTODOC recommends:
Some cars are not equipped with wheel hub caps. 7. Unscrew the wheel hub axle nut.
Use drive 12-point socket #30. Use a tap wrench. 8. Remove the hub and the bearing together, since they are a sealed unit. 9. Clean the hub bearing mounting seat.
Use all-purpose cleaning spray. 10. Install the new wheel hub with a bearing. 11. Tighten the hub. Use drive 12-point socket #30.
Use a torque wrench. Tighten it to 155 nm torque. AUTODOC recommends:
The wheel bearing unit must not tilt on the axle pin. 12. Install the hub bearing protection cap.
Use a rubber mallet. 13. Treat the hub where it contacts the brake disk.
Use copper grease. 14. Install the brake drum and fasten it. 15. Tigten the brake drum fasteners.
Use a Phillips screwdriver. Use a torque wrench.
Tighten it to 15 Nm torque. 16. Clean the wheel rim mounting seat.
Use a wire brush. 17. Treat the contacting surface.
Use copper grease. 18. Screw in the wheel bolts.
Use wheel impact socket #17. AUTODOC recommends:
To avoid injury, hold up the wheel when screwing in the fastening bolts. 19. Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench.
Tighten it to 120 nm torque.

1 thought on “How to replace rear wheel bearing / rear hub bearing on VW POLO 4 (9N) [TUTORIAL AUTODOC]”

  1. Алексей A. says:

    Good 👍👍👍

Leave a Reply

Your email address will not be published. Required fields are marked *