Mounting spherical roller bearing with cylindrical bore using induction heater
Mounting spherical roller bearing with cylindrical bore using induction heater


Mounting spherical roller bearing with a cylindrical bore using induction heater Coat the sliding surfaces with a thin layer of light oil or mounting paste Place the backing ring on the shaft for to facilitate future dismounting process Place the bearing into the induction heater and connect temperature sensor to bearing inner ring Power on induction heater and set final heating temperature Start the heating process and wait for reaching final temperature Disconnect temperature sensor, press STOP which will demagnetize the bearing and grab it with heat-resistant gloves bearing needs to be immediately placed on the shaft It is important to place it to the correct position! Place the locking washer and locking nut With the use of hook spaner tight the locking nut Secure the locking nut by pushing lip of locking washer into the groove of locking nut

Leave a Reply

Your email address will not be published. Required fields are marked *