Redline Replacement Magnet Kit for Dexter Electric Brakes Installation – etrailer.com
Redline Replacement Magnet Kit for Dexter Electric Brakes Installation – etrailer.com


Today in our trailer we’ll be installing the replacement kit for for Dexter 12 1/4 inch electric brake assemblies It is part number BP01-301 This oval-style magnet kit with yellow wire allows you to replace only the worn out magnet on your Dexter trailer brakes, rather than the higher assembly The overall design increases the efficiency of the magnet, while also extending the life of the magnet Now we’ll show you how to install it All right, with our wheel off of our trailer, the first thing we need to do is remove our grease cap here Make sure we have a drain pan underneath, because this particular trailer uses hub oil versus actually axle grease

6 thoughts on “Redline Replacement Magnet Kit for Dexter Electric Brakes Installation – etrailer.com”

  1. Frank says:

    help a lot thanks

  2. Javier Munoz says:

    Thank for the video, I have a question, “why didn’t you use a torquing wrench?

  3. Race Mentally says:

    I’ve never had one of our guys that dirty in the shop. Love it! Haha

  4. Rashid R says:

    I’m having a problem with my electric trailer brakes. They work but just barely they don’t feel strong enough and they barely slow down my trailer when I hit the brakes. My truck Gail is on 10 and I replaced my trailer brakes. Anyone can help?

  5. mickey gentry says:

    alot of bad advise, the nut should only be torqued enough to preload the bearing, the outer plastic cover will break it tightened the way shown and way too much oil. the oil bath axles have a line on them to show the oil level. if too much oil then you will have a leaking oil seal.

  6. John VH 2019 says:

    Always use a new cotter pin.

Leave a Reply

Your email address will not be published. Required fields are marked *