Remove the rear wheels. Use a hammer. Use a flat screwdriver. Remove the hub bearing protection cap. Use a drive socket No.30. Unscrew the wheel hub fastening nut. Remove the brake drum. Use a pliers. […] Read More

Required tools: Wire brush WD-40 spray Copper grease Combination spanner #21 Combination spanner #22 Drive socket # 17 Wheel impact socket #21 Ratchet wrench Torque wrench Tap wrench Flat Screwdriver Round-nose pliers Vernier caliper Crow […] Read More

Use a combination spanner №16 Use a torx №T30 Use a socket №E14 Lubricate the brake disc seat with copper spray

Required tools: Wire brush WD-40 spray Copper grease Drive socket # 15 Drive socket # 21 12-point socket # 24 XZN socket bit # 12 Torx bit T30 Wheel impact socket #17 Ratchet wrench Torque […] Read More

Raise the rear of the car and secure on supports. Remove the hub bearing protection cap. Use a hammer. Use a flat chisel. Use a drive socket No.30. Loosen and remove the hub nut. Remove […] Read More

Use a socket №12 Remove the hub bearing cap Use a socket №32 Treat the brake drum seat with a copper grease

Use a socket №17 Use a socket №24 Use a combination spanner №18 Use a socket №13 Use a socket №16 Use a socket №17 and a combination spanner №17 Using hydraulic press, press off […] Read More

Use a socket №30 Use a socket №17 Using sidecutting pliers remove the cotter pin Use a combination spanner №17 Use a special puller to take the tie rod end out Use an open-end wrench […] Read More

Use a socket №12 Treat the brake drum seat with a copper grease

Required tools: Wire brush WD-40 spray Copper grease Drive socket # E14 Drive socket # 19 Drive socket # 21 Drive socket # 36 HEX bit No.H4. HEX bit No.H7. Wheel impact socket #17 Ratchet […] Read More