I have always wondered what it would look like if I laid out a completer bike in parts on the floor the bike I’m working on right now is an O 3 CR 250 and […] Read More

you guys have no idea how excited I am to finally put together this wheel set this is gonna be a lot of fun it’s going together in the exact color combo that I’ve been […] Read More

hey guys welcome back to the channel today I have got my work cut out for me as you can imagine engine parts are some of the dirtiest parts on a dirt bike so I’m […] Read More

welcome back everyone as I’m sure most you saw in the last video I did some powder coating on these hubs back here and the next step is gonna be installing some fresh bearings into […] Read More

Hi, this is Eric from Rocky Mountain ATV/MC.com And today I’m going to show you how to separate a main bearing from a crankshaft. And to do it we’re going to use the Tusk Bearing […] Read More

This is Part 2 of the Split Cases, Crank and Crank Bearing Replacement Video. Please refer to Part 1 for the previous dis-assembly. Using the Tusk Case Splitter. We’re going to go ahead and put […] Read More

I’ve got a fun little project I’m gonna share with you guys here is the radiator set off of my Oh three cr250 and when I started out with them they were completely mangled all […] Read More

In this video, we’ll demonstrate how to properly remove worn out steering stem bearings. We’ll also show you how to pack your new bearings with grease and install them onto your bike. These steps can […] Read More

I got a question for you guys do you think this radiator is repairable it’s got a huge Bend on the side of it and it’s also twisted from top to bottom I don’t know […] Read More

Good to see you guys again got another video for you today. We’re gonna be working on the little XR back here This is my girlfriend’s bike Honestly, I wish I was working on the […] Read More