Tag: off road

BALLER SIXER 1 SAMURAI CHASSIS BUILD – 1/6 scale CAPO Trail Truck BV4 | RC ADVENTURES
BALLER SIXER 1 SAMURAI CHASSIS BUILD – 1/6 scale CAPO Trail Truck BV4 | RC ADVENTURES

– [RCSparks] Well, here we are guys. It’s been a wonderful build so far, I hope you’ve been enjoying it, make sure to smash that Like button if you’ve been watching the series. This is […] Read More

Motorcycle Bottom End Rebuild | Part 3 of 3: Final Assembly
Motorcycle Bottom End Rebuild | Part 3 of 3: Final Assembly

This is Part 3 of the split cases, crank and crank bearing replacement video. Please refer to Parts 1 and 2 for the previous procedures In Part 2 we installed the crank into the right […] Read More

How to Service/Maintenance Wheel Bearing for Lifetime Endurance – 4×4 AUTO LOCKER HUB.
How to Service/Maintenance Wheel Bearing for Lifetime Endurance – 4×4 AUTO LOCKER HUB.

it’s been approximately 40,000 miles since we have serviced this wheel bearing for the 4×4 front differential on the 2003 Nissan Frontier what we want to do now is we want to service this wheel […] Read More

Motorcycle Wheel Bearing Replacement

Hi, I’m Eric from Rocky Mountain ATV/MC.com and today i’m going to show you change wheel bearings. We’re going to do that today using our Tusk Bearing Removal Tool. Some things we’re going to need […] Read More

ATV or Motorcycle Crank Bearing Removal – Crankshaft Repair
ATV or Motorcycle Crank Bearing Removal – Crankshaft Repair

Hi, this is Eric from Rocky Mountain ATV/MC.com And today I’m going to show you how to separate a main bearing from a crankshaft. And to do it we’re going to use the Tusk Bearing […] Read More

Spider Gear Installation Explained | Differential Tech Tips
Spider Gear Installation Explained | Differential Tech Tips

Thanks for taking the time to watch Yukon Tech Tips. Today we’re going to be discussing how to install a set of spider gears in a standard open differential. This is amazing how difficult these […] Read More

Motorcycle Bottom End Rebuild | Part 2 of 3: Crank & Bearings
Motorcycle Bottom End Rebuild | Part 2 of 3: Crank & Bearings

This is Part 2 of the Split Cases, Crank and Crank Bearing Replacement Video. Please refer to Part 1 for the previous dis-assembly. Using the Tusk Case Splitter. We’re going to go ahead and put […] Read More

How to Remove Rearend Differential Carrier/Bearing/Shim. PART 4/13
How to Remove Rearend Differential Carrier/Bearing/Shim. PART 4/13

move these four boots follow the differential carrier position these two are the shackle this is the carrier ring gear have a 17 millimeter socket and it’s a half inch drive you preferably want to […] Read More

Clutch Replacement On A Motorcycle or Atv – Clutch Installation
Clutch Replacement On A Motorcycle or Atv – Clutch Installation

HI, I’m Eric from Rocky Mountain ATV/MC.com And today I’m going to show you how to replace a clutch on an atv or a motorcycle. To start with you are going to need a service […] Read More